Heating and air conditioning car BMW 7 Series E38

General information about the heating, ventilation and air conditioning system
Description of systems The description of the control of the ventilation system with a heater and K / V is given in the Chapter Controls and methods of...

Removal and installation of a heater
1. Remove hoses (1) cooling systems on the bulkhead of the engine compartment. Blow out the lines carefully to remove any remaining coolant from the radiator....

Removal and installation of a heater radiator
Models with an integrated heating system and A/C 1. Remove the engine top cover. 2. Remove hoses ( 1 ) cooling systems on the bulkhead of the engine...

Removal and installation of fans and resistor assemblies
Fan of the unit of the integrated heating system and A/C 1. Remove facing of the panel of devices (see chapter Body ). 2. Release the air duct clamp. 3. Fold...

Removal and installation of additional water pump and water valve
Additional water pump (on the fan cover) 1. Remove the front engine accessory guard. 2. Disconnect the connector (1) and remove the water hoses (2). 3. Remove...

Removal and installation of deflectors of systems of heating, ventilation and conditioning
Side deflectors 1. Before removing left deflector do the following: 2. Remove the wooden plank and disconnect the connector for the instrument panel backlight...

Removal and installation of the compressor of the conditioner
1. Remove the accessory protection panel. 2. Drain the refrigerant, if necessary, replace the dryer tank. 3. Remove the K/V compressor drive belt (see chapter...

Removal of other components of the air conditioning system
Evaporator, stop and safety valves 1. Remove the block of heating and К/В. 2. Remove expansion valve. 3. Loosen the clamps on the left and right sides and...