Withdrawal
Remove the hand brake lever.
Remove the hand brake pads.
Squeeze out pin -1- and remove handbrake release buckle.
Unscrew bolts -2- for support of Bowden cable.
Remove the handbrake cable and pull it out of the protective tube.
Installation
Route the cable to the hand brake lever and to the rear wheel brake.
Attention: When pulling the cable through the protective tube, make sure that the support of the Bowden cable rests on the protective tube.
Hang the Bowden cable in the plastic clip.
Slide support onto handbrake cable and secure with two bolts -2- to brake shield.
Complete the rear brake.
Install handbrake lever
Adjust handbrake.