Generator — general information and device On BMW cars, an alternator is installed. Depending on the model and composition of the equipment, the generator power can be from 80 A to 115 A. The generator...
Alternator Safety Precautions When working in the engine compartment, be sure to disconnect the ground wire from the battery. Do not interchange the wires of the voltage regulator and the...
Removal and installation of the generator Note: Additional instructions for 520i/525i models from May 1990 are at the end of this section. Withdrawal On models 518i, 520i, 525i: Disconnect the ground...
Checking the voltage regulator Connect a voltmeter to the positive and negative battery terminals. Start the engine. During start-up, the voltage can drop to 9.5 volts. Increase the speed to...
Starter — general information and device To start an internal combustion engine, a small electric motor, a starter, is required. To start the engine, it is necessary that the starter develop up to 300...
Removal and installation of a starter The starter is located on the side of the junction of the engine with the gearbox and is removed upward. Withdrawal Caution: Disconnect the battery to avoid...
Removal and installation, check of the traction relay With a defective traction relay, the starter gear does not engage with the flywheel ring gear. Because of this, the starter is not able to crank the engine....
Starter Troubleshooting If the starter does not turn the engine, first check for a voltage at terminal 50 of the traction relay of at least 8 volts, sufficient to operate the traction...