Withdrawal
Remove inner door trim.
Carefully remove the seal from the door cutout.
Lower glass. Remove side clips -arrows-.
Press the glass out of the spherical fastening heads and move it by hand upwards along the guide. Use a suitable hook to secure the glass from falling.
Remove microswitch and disconnect connectors 1 and 2.
Using a 6 mm drill, drill out the four rivets -arrows- for the power window.
Loosen bolt 1.
Remove the power window assembly.
If necessary, unscrew the motor from the power window mechanism (3 bolts).
Installation
Insert, align and screw the power window mechanism. During installation, drilled rivets should be replaced with M6x10 mm bolts. From the rear, screw on and tighten the nuts with washers.
Lower the glass, insert it into the guide and secure with 2 clamps