Withdrawal
Suck out the brake fluid from the expansion tank to the level of the top-up pipe.
Raise the car.
Unscrew slave cylinder -1- from gearbox.
Unscrew hose -2-.
Attention: If the slave cylinder does not need to be replaced, the hose remains connected.
Installation
Lubricate the slave cylinder piston rod with Molykote Longtherm 2.
Screw on the hydraulic hose with a tightening torque of 12 Nm. Insert the slave cylinder and tighten the mounting bolts with a tightening torque of 15 Nm. The bleed valve must point downwards.
Fill with brake fluid. Bleed the air from the hydraulic clutch actuator.