Withdrawal
Disconnect the ground wire from the battery.
Unscrew the electrical wires from the pump, after opening the protective caps.
Loosen the clamps and disconnect the fuel hoses. To prevent fuel from escaping, first close the hoses with clamps or, after disconnecting, close the ends of the hoses with suitable screws. Wipe up leaking fuel with a cloth.
Unscrew 3 nuts and remove the cover of the mounting bracket.
Remove the fuel pump together with the mounting bracket.
Unscrew the fuel pump from the bracket and remove the rubber ring.
Installation
Check for cracks and damage to the rubber support and. if required, replace it.
Screw the fuel pump to the bracket and insert into place.
Screw on the bracket cover with 3 nuts.
Connect fuel hoses and secure with clamps.
Caution: The discharge hose must only be secured with a screw clamp.
Remove clamps from hoses.
Screw on the electrical wires and close the pads with rubber caps.
Connect ground wire to battery.