Withdrawal
Attention: Do not make open fire! Fire hazard!
Clamp the underwater and pressure fuel hoses -1- and -2-. If there are no appropriate clamps, disconnect the hoses and close them with screws of the appropriate diameter so that no fuel flows out.
Disconnect the fuel hoses from the pump, after completely releasing the clamps.
Loosen 2 nuts (arrows) and remove the fuel pump together with the insulating flange -H-.
Pull out the pusher a little.
Installation
Check the integrity of the insulating flange. If necessary, replace the insulating flange.
Check the ease of movement of the pusher.
Install the fuel pump together with the insulating flange and tighten the bolts to 15 Nm.
Connect fuel hoses and secure with clamps. Hose -1- goes to fuel tank or fuel filter, hose -2- goes to carburetor.