Remove air filter (see section «Removal and installation of the air filter»).
Operate the throttle lever -1- to unload the nipple -6- of the throttle cable.
Compress clamp -2- and press it away from throttle valve lever.
Disconnect the throttle cable through the slot on the throttle lever.
Unscrew retainer -3- from carburetor and place to one side with throttle cable.
Connection
Screw the holder with the throttle cable to the carburetor.
Insert the throttle cable through the slot into the hole in the throttle lever.
Give the throttle lever a little gas, put and press the bracket.
Check throttle cable adjustment.
Install air filter (see section «Removal and installation of the air filter»).
Hose routing on a 2BE carburetor
1 Air filter housing
2 Air valve
3 Inlet pipe temperature switch
4 Vacuum diaphragm 2nd stage
5 Throttle control
6 Filter
7 Solenoid valve
8 Vacuum diaphragm of the ignition distributor
9 Hose connection to the vehicle interior