Car Clutch Repair BMW 3 Series E21

Detailed technical specifications
The clutch is dry, single-disc, with a central pressure spring. Clutch release drive hydraulic with automatic clearance adjustment. Clutch brand: F (Fichtel)...

Clutch parts
Clutch details: 1 - pressure plate; 2 - driven disk; 3 - clutch release fork; 4 - clutch release bearing; 5 - fork spring; 6 - pin; 7 — a bolt of fastening of...

Clutch Hydraulic Drive Details
Clutch hydraulic parts: 1 - main cylinder; 2 — a reservoir of a hydraulic drive of coupling and brakes; 3 - filter; 4 - cork; 5 — a pusher of the piston of the...

Removing the clutch
Remove the gearbox. With the clutch installed on the vehicle, make sure that the deviation from the flatness of the ends of the pressure spring petals does not...

Checking the status of the slave disk
The condition of the clutch disc can be checked directly on the vehicle. Put the car on a lift and insert template 212060 between the clutch housing and the...

Clutch control
Thoroughly clean the clutch mechanism and visually check the condition of the rivets and the fastening of the driven plate vibration damper springs. Check the...

Clutch installation
Be convinced of free movement of a nave of a conducted disk on splines of an input shaft of a transmission. Lubricate the shaft splines with a thin coat of...

Replacing the clutch release bearing
To perform this operation, the gearbox must be removed. Remove the clutch release fork retaining spring, release fork and release bearing. Check the height of...

Removal and installation of the clutch master cylinder
Withdrawal Remove the left lower facing of the panel of devices. On vehicles with a 4-cylinder engine, disconnect the cable from the accelerator pedal and...

Removing the clutch slave cylinder
Suck out the working fluid from the reservoir of the hydraulic clutch and brakes with a syringe. Disconnect from the working cylinder the pipeline going from...

Pumping the clutch hydraulic drive
Clean the bleed screw on the working cylinder from dust and dirt and unscrew it about 1.5 turns. Place a hose over the head of the fitting and immerse the...